Stainless steel hydraulic joints are suitable for working under high pressure, vibration and tightness requirements. Improve the sealing characteristics, pressure resistance and shock resistance of the pipe joint. So what should be paid attention to when installing stainless steel hydraulic joints?
The use of straight butt joints for stainless steel pipe fittings has high requirements on the quality of pipe fittings. There are high requirements for the ellipticity and thickness of the diameter and thickness of the cast iron drainage pipe of the drainage pipe and the physics of the rubber ring and the physics of the rubber ring. The prerequisites for the tightness of straight ports are poor. Therefore, in addition to strictly controlling the quality of pipe fittings and pipe fittings, high-pressure flanges must also pay special attention to the port numbers of pipe fittings and pipe fittings. Shape and flatness. During the construction of the equipment project, it shall be implemented strictly in accordance with the actual operation process.
Seamless splicing stainless steel pipe fittings are strip-shaped stainless steel plates with hollow cross-sections and no joints nearby. The thicker the thickness of seamless splicing stainless steel pipe fittings, the more reasonable and commonality. The thickness of the wall is thicker, and the production cost of customized welded joints will be greatly increased. The pipe fittings have a hollow cross-section, which is a kind of pipeline that admits liquid in advance, and pipelines that admit some solid chemical substances in gas, crude oil, liquefied gas, and water purifier in advance. Compared with solid-core stainless steel plates such as Yuangang, seamless splicing stainless steel pipe fittings have the same bending strength, torsion and compressive strength, the harder the net weight, which is a cross-sectional stainless steel plate for economic development, and is used throughout the production of parts. And mechanical parts, such as steel pipe scaffolds for construction pipes, bicycle frames, transmission shafts, crude oil drilling tools, etc., if the distance between the two sockets on the horizontal riser butt sanitary ware is not more than 600mm, it can be in the management center Set up a bracket.