How to deal with the technical problems of abrasion and cracking caused by the repeated movement of the cable in the current technology? At this stage, many cables are all on both sides of the motor, and no protective equipment is used. Long-term repeated movement is very easy to cause wear and tear. The stainless steel joint is composed of the joint itself, the shrapnel collar, the clamping screw cap, the anti-bending elastic yellow, the hydraulic seal and the O-ring. The joint itself has inch threads on both sides. When the clamping screw cap is rotated, the hydraulic pressure can be driven The seals are tucked in, which in turn encourages the cable to bind the seal.



The shrapnel collar and the cable shield are connected to each other, which can have the effect of correctly guiding the shield. When the connector itself is tightened, the shrapnel can be squeezed, so that the shrapnel clip can clamp the shielding layer of the cable, so as to ensure that the radio waves caused by the cable during operation are properly grounded, and the information content is not easy. Because the cable shielding is invalid, The other end of the shrapnel clamp cooperates with the hydraulic seal to achieve the actual effect of sealing; when the metal material lock cap is clamped, the hydraulic seal installed on the side of the connector itself can seal the cable; the external group of the cable exits The back is covered in the anti-bending elastic yellow. When the long-term vibration of the motor causes the long-term repeated movement of the cable, the stress can be reasonably digested and absorbed, especially in the wheel-side motor in the new material industry; the copper shrapnel collar can The shielding layer of the cable is tightly bound, so that the shielding layer of the cable is not easy to move. In addition, it can guide the radio waves reasonably and correctly, and has the actual effect of shielding by the grounding device. Its compatible O-type flat and flat one-piece sealing ring is placed in the groove. When installing the product, the O-ring is extruded and formed to withstand the force, which is a vertical force, not an axial force (it is very easy to cause the O-ring to be distorted and deformed. There are invalid cases), so as to ensure the tightness. If the cable must be repeatedly moved for a long time, the stainless steel joint has excellent corrosion resistance, temperature resistance, ultra-low temperature compressive strength and physical properties. I believe that you should have a certain grasp of how to deal with the wear and tear of the cable for the stainless steel joint.